Best HP Certification Training and HP Exams Training
and more HP exams log in to Certkingdom.com
QUESTION 1
Using the MSA1000 Software Support CD, which installation options do you have? Select TWO.
A. new firmware
B. Windows drivers
C. MSAFlash utility
D. Secure Path
E. ACU-XE
Answer: B,E
QUESTION 2
You have a configuration with 3 virtual disks configured in one array. One virtual disk is RAID 0,
one is RAID 5 and one is ADG. Identify the correct statements if one hard drive has failed and you
remove a wrong (running) drive from this array. Select TWO.
A. RAID 5 has data loss when you remove the wrong drive.
B. RAID 5 has data loss after first drive failure.
C. ADG is still online.
D. RAID 5 is still online.
E. ADG has data loss when you remove the wrong drive.
Answer: A,C
QUESTION 3
Click the Exhibit button.
On an MSA1000 disk, all LEDs are OFF. What are possible causes for the status and which
actions should you take? Select TWO.
A. The array is performing an online expansion. Do not remove this drive without verifying the
configuration.
B. The drive is not configured as part of an array. You can remove the drive.
C. The array is rebuilding. Do not remove this drive without verifying the configuration.
D. The drive is configured as a hot spare. If needed, you can remove the drive.
E. The drive is part of the selection of the array configuration utility. Do not remove this drive
without verifying the configuration.
Answer: B,D
QUESTION 4
Which cable can be used to connect an MSA1000 with I/O-module to a 1 Gb SAN switch?
A. LC to SC
B. SFF to SFP
C. SC to SC
D. LC to LC
Answer: A
Best HP Certification Training and HP Exams Training
and more HP exams log in to Certkingdom.com
No comments:
Post a Comment